Quick Starter Guide : S3 GSM Alarm Panel

Problems about Burglar Alarm
Post Reply
admin
Site Admin
Posts: 1911
Joined: Tue Apr 17, 2007 2:08 pm

Quick Starter Guide : S3 GSM Alarm Panel

Post: # 1749Post admin
Thu Aug 19, 2010 10:07 am

Configuration of the S3 GSM alarm panel is ever the most friendly panel. It's easy.

All unit we ship out has been configured, but in case you do it yourself and looks not working, we suggest having the unit reset and everything start-over in order not to be confused.

1) take one door sensor out. check the jumpers as. and have it ready for signalling.
Image
2) put in your SIM card ( make sure it has no any password or keystroke required for it to dial out )
3) fasten the antenna
4) put in the power adapter
5) turn off the unit first
6) press and hold the SET or RESET button at the back
7) turn on the power
8) few seconds, release the SET
9) use a remote control bundle, check if it can arm or disarm the panel; if no response, good, reset succeed
10) now press the SET button again until you see all zone RED light ON, release - this is the mode for setting remote control, trigger remote control, you should hear 2 beeps (means successful)
11) now press SET button again, only 1st zone RED light ON, now trigger the door sensor, hear 2 beeps (means door sensor learnt). You can learn other sensors one by one here. OR
12) now press SET once again, you should see 2nd zone RED light ON, now it's for 2nd zone settings. you can press more for zone 3rd, 4th, 5th and 6th. when all 6 zones light OFF, it has left the config mode, the alarm is ready.

Post Reply

Who is online

Users browsing this forum: No registered users and 10 guests