GSM II Alarm Panel Installation Make Simple
Posted: Fri Mar 26, 2010 12:08 pm
Installation Simple Step by Step
Our engineer will pre-configure the system for you; in that sense, your system ordered is also tested before shipped. However, the installation is straight forward.
Step 1: Install all batteries to motion detector, remote controller and door sensor.
Step 2: Put your SIM card into the control panel ( make sure the SIM card supported a compatible GSM network )
Step 3: Fasten the antenna (make sure fasten the contact points contacted well)
Step 4: Connect the adapter with control panel, turn it on.
Step 5: Indicator shows 'red' for configuration mode.
Step 6: Trigger the sensors to signal the control panel for their presenses, you will see 'red' indicator flashing.
Step 7: Wait for time-out and control panel switched to operation mode automatically.
Step 8: Send your first configuration command of configuring the phone number for alert to control panel by SMS.
You have basically done.
Details of operation can be referred to manual and can be downloaded from the manual section of this forum.
Our engineer will pre-configure the system for you; in that sense, your system ordered is also tested before shipped. However, the installation is straight forward.
Step 1: Install all batteries to motion detector, remote controller and door sensor.
Step 2: Put your SIM card into the control panel ( make sure the SIM card supported a compatible GSM network )
Step 3: Fasten the antenna (make sure fasten the contact points contacted well)
Step 4: Connect the adapter with control panel, turn it on.
Step 5: Indicator shows 'red' for configuration mode.
Step 6: Trigger the sensors to signal the control panel for their presenses, you will see 'red' indicator flashing.
Step 7: Wait for time-out and control panel switched to operation mode automatically.
Step 8: Send your first configuration command of configuring the phone number for alert to control panel by SMS.
You have basically done.
Details of operation can be referred to manual and can be downloaded from the manual section of this forum.